How To Change The Cabin Filter In A Mini Cooper F56

In this guide, nosotros'll run through the steps for replacing an air filter on a MINI F56 Cooper S & JCW models. Please note that this applies for both pre-LCI and LCI F56 models but not the latest GP3 model.

For help with irresolute an air filter on previous generation models, view our guides here:

• How to fit an air filter to a MINI R53 Cooper Due south & JCW
• How to fit an air filter to a MINI R56 Cooper S & JCW

Changing an air filter on your MINI F56 is relatively straightforward and may take you a couple of hours at habitation. With the right equipment, a bit of patience and our step by step guide you lot can easily complete this job on the driveway.

If you're unsure, or just don't fancy doing it yourself - contact our squad on 01785 859999 or [email protected] and we can suit to do this for you or as office of a service.

Knowing when to change your air filter

If y'all're taking office in rails or race days, are doing higher than the usual mileage or are noticing a drop in performance then it might exist a adept time to change your air filter.

As a rule of pollex, air filters should be cleaned or inverse either at your annual service or with every x,000 miles to ensure that information technology retains its ability to block out contaminants whilst preserving airflow and does not become damaged.

A torn air filter could result in harmful debris entering the engine, whilst a blocked air filter may mean that insufficient levels of oxygen within the engine causes a drib in performance or causes running problems such as mis-firing.

OEM vs aftermarket air filters

The stock newspaper filters which are the default variation in MINIs will provide adequate performance for full general apply and regular 24-hour interval-to-solar day driving. These are usually replaced every 3 to 4 years or every xv,000 to 25,000 miles.

Aftermarket filters, such as the ITG ProFilter provide a college level of operation and have the added benefit of being able to be cleaned, rather than having to be replaced, saving you coin in the long term.

For performance driving or track days, we'd highly recommend investing in an aftermarket filter for improved airflow and better protection against air contaminants.

It'due south of import to know that the onboard reckoner volition not monitor and alarm you when your filter needs changing.  It's advisable to check your filter at least once a year and if it's dirty and then it's time to replace it.

In the steps below, nosotros'll run through how to supplant the OEM air filter with an aftermarket air filter on a MINI F56.

Equipment required

1x performance air filter (we recommend the ITG Foam Filter)

1x ITG Air Filter Cleaning Kit (optional)

1x flat-headed screwdriver or 7mm socket

1x Torx T20 screwdriver

Stride by Stride Guide

Step i

Open up up the bonnet and locate the airbox, which is towards the right hand side of the engine bay.

Step 2

Carefully unplug the MAF Sensor Plug from the housing.

Stride 3

The wiring for the sensor is held in place with a cable tidy, unhook this clip which holds the wiring loom in place.

Stride 4

Using a flathead screwdriver unscrew the jubilee clip which holds the pipe in place and then firmly simply carefully pull out the pipe from its housing.

Step 5

Surrounding the airbox in that location are iii screws which all need to be removed. You lot tin do this with a Torx T20 screwdriver, which loosens the airbox.

Step 6

Lift up and remove the airbox, which reveals the air filter that needs to be either removed and cleaned, or replaced with your new performance air filter. If you're removing your filter to be cleaned, and so you'll demand to utilise some other coat of grease. We recommend the ITG Air Filter Cleaning Kit, which removes grime and reapplies oil to take hold of boosted dust particles.

Step 7

Remove the filter along with any debris or contaminants that may accept congenital upwards in the airbox over time.

Footstep 8

Place your new filter inside the housing, ensuring that information technology fits without any gaps. If you're fitting a new performance filter, like ane of ITG's foam filters, they usually come pre-greased.

Step nine

Once the filter is in situ, follow these instructions in reverse to rebuild the airbox and ensure that the MAF sensor plug is deeply attached.

Hopefully, this step by stride guide will have given you all you need to undertake this job on your driveway. Remember, make certain you at least bank check your air filter every 12 months or 10,000 miles to ensure that it performs to the best of its ability.

For more assist or to get your MINI booked in at Lohen for an air filter change, please contact our team on 01785 859999 or [email protected]

Store MINI AIR FILTERS FOR GEN 1 / GEN 2 / GEN 3

1 September 2020

690 view(south)

Source: https://www.lohen.co.uk/blog/fit-air-filter-to-a-mini-f56.html

Posted by: friendhintailging.blogspot.com

Share this post